student_documentation:jm2
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| student_documentation:jm2 [2024/08/07 06:39] – [BE] Melle de Wit | student_documentation:jm2 [2024/08/07 06:43] (current) – [H2] Melle de Wit | ||
|---|---|---|---|
| Line 50: | Line 50: | ||
| - Where equipped, connect the USB cable to the Joulemeter and the On-Board Computer (OBC) USB. You MUST NOT use your own USB cables. Use the cable provided, it electrically separates the JM from the On-Board Computer. | - Where equipped, connect the USB cable to the Joulemeter and the On-Board Computer (OBC) USB. You MUST NOT use your own USB cables. Use the cable provided, it electrically separates the JM from the On-Board Computer. | ||
| - | ==== ICE ==== | + | ==== Internal Combustion Engine |
| The Joulemeter should be installed between the vehicle’s accessory battery and the vehicle’s electrical system. As shown in the figure below, both the positive and negative battery leads pass through the Joulemeter. | The Joulemeter should be installed between the vehicle’s accessory battery and the vehicle’s electrical system. As shown in the figure below, both the positive and negative battery leads pass through the Joulemeter. | ||
| Line 57: | Line 57: | ||
| - | ==== BE === | + | ==== Battery Electric |
| The joulemeter should be installed between the propulsion battery and the vehicle electrical system. As shown below, both the positive and negative battery leads pass through the Joulemeter. | The joulemeter should be installed between the propulsion battery and the vehicle electrical system. As shown below, both the positive and negative battery leads pass through the Joulemeter. | ||
| Line 63: | Line 63: | ||
| - | ==== H2 ==== | + | ==== Hydrogen Fuel Cell ==== |
| - | The Joulemeter should be installed between the battery and the vehicle’s electrical system. | + | The Joulemeter should be installed between the accessory |
| Line 75: | Line 75: | ||
| - | ==== Trouble Shooting ==== | ||
| - | The table below provides a number of troubleshooting options for cases where anomalies are detected. | ||
| - | |||
| - | Please check the contents of this section before seeking assistance. | ||
| - | |||
| - | ^Condition^ Possible Causes^ Solutions^ | ||
| - | |The LEDs remain dark when I press the Start Button on the On-Board Computer|OBC battery is not correctly connected to the Backbone \\ OBC battery is discharged|Verify battery cable is connected to the Backbone \\ Charge battery| | ||
| - | |:::|Pod not correctly connected to the Backbone|Check cable and plug| | ||
Log In (for D&T Team and Volunteers ONLY) student_documentation/jm2.1723012756.txt.gz · Last modified: 2024/08/07 06:39 by Melle de Wit