student_documentation:relay
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| student_documentation:relay [2023/12/04 15:05] – Beni Ammann | student_documentation:relay [2024/07/03 02:22] (current) – Beni Ammann | ||
|---|---|---|---|
| Line 13: | Line 13: | ||
| Before the event, teams should identify and test with a switch the circuit that will be wired through the shutdown relay. | Before the event, teams should identify and test with a switch the circuit that will be wired through the shutdown relay. | ||
| + | |||
| + | The maxumum current flowing through the Relais must not exceede 2 Ampere | ||
| + | |||
| ===== ICE ===== | ===== ICE ===== | ||
| Line 22: | Line 25: | ||
| - | **Maximum current = 1 amps** | + | **Maximum current = 2 amps** |
| + | **Maximum voltage = 24 volt** \\ | ||
| Line 34: | Line 39: | ||
| {{ : | {{ : | ||
| - | THE SHUTDOWN RELAY MUST NOT BE CONNECTED TO THE IGNITION COIL OR E-STOP. | + | THE SHUTDOWN RELAY MUST NOT BE CONNECTED TO THE IGNITION COIL. |
| Line 45: | Line 50: | ||
| - | **Maximum | + | **Maximum current = 2 amps** |
| + | **Maximum voltage = 24 volt** \\ | ||
| * Option 1 - disables motor control when activated | * Option 1 - disables motor control when activated | ||
Log In (for D&T Team and Volunteers ONLY) student_documentation/relay.1701702327.txt.gz · Last modified: 2023/12/04 15:05 by Beni Ammann